As I had closed the gap in the neck pocket, it was now time to screw on the neck in order to measure the bridge positioning.
The holes in the neck were drilled too large, and it took me three attempts to find screws that would be the appropriate size. I finally found some stainless steel screws - not in any of the hardware stores that I visited for this, but finally in one of my favorite music stores...
The screws were a bit too long, so I had to shorten them - so that finally I could screw the neck on...
Now the neck fits into the pocket tighly, and the gap is much smaller than before...
The holes in the neck were drilled too large, and it took me three attempts to find screws that would be the appropriate size. I finally found some stainless steel screws - not in any of the hardware stores that I visited for this, but finally in one of my favorite music stores...
The screws were a bit too long, so I had to shorten them - so that finally I could screw the neck on...
Now the neck fits into the pocket tighly, and the gap is much smaller than before...
No comments:
Post a Comment